  
      |
| |
LUBEGARD® Automatic Transmission Cooler Flush
 |
 |
| Specifications |
|
Item #
|
Unit Size
|
Case
Quantity
|
|
19002
|
11.75 oz.
|
12
|
Price: $11.95 each
1-3 cases: 20% discount
4+ cases: 35% discount
FREE Shipping on all orders!
|
|
This convenient oil-based solvent saves
time and money for general service and
repair shops. It will prevent contaminating
new or rebuilt transmissions you install.
Use instead of an expensive cooling
system flushing machine to clean system
and prevent cross contamination.
FOR PEOPLE WHO DON'T HAVE A
DEDICATED COOLING LINE FLUSHER
A three-in-one product
The flush can is used to prevent transmission
contamination by removing and eliminating
contaminants such as grease, dirt, sludge,
grime and metal shavings in transmission
cooling systems and lines, without leaving
any water or soapy residue in the system.
It also cleans electric parts, wire harnesses,
etc. leaving a thin layer of dielectric
protectant.
|
|
has three uses in one:
 |
(wire harnesses & solenoids),
electronic engine connnections (computers,
sensors & wiring) |
 |
| 1. Line
Flush Cleaner |
2. Electronic
Transmission Cleaner |
3. Dielectric
Protectant |
Benefits
- Leaves no soapy residue.
- Contains no water.
- Prevents contamination.
- Prevents costly comebacks.
- Contains no ozone depleting chemicals
or CFCs.
- Contains no chlorinated solvents.
- Easy to Use .
There have been many debates about the
use of water-based detergent cleaners
(soaps) and oil-based solvent cleaners.
Water-based transmission cleaners have
high detergent and dispersant levels,
and once flushed through the system leave
behind a film of the detergents, water,
dispersant and/or ATF emulsion on the
walls of the tubing. The water and chemicals
remaining, which are not good for your
transmission, will become part of the
new ATF when the transmission is re-installed.
Using an oil-based cleaning method makes
sense; the technician can ensure that
the new ATF stays dry and that the transmission
is reassembled to last.
Directions for Use
For Line Flush Cleaner:
Attach connector to transmission feed
line. Next, attach hose to transmission
return line to collect flush and residue
in a waste container. Hold can upright
and actuate. Flush until clear. For best
results use entire content of can per
installation. Then turn can upside down
and continue cleaning with air only.
For Wire Harness Cleaner:
Cut off hose to appropriate length to
direct the stream. Spray over dirty depowered
6-12 volt electrical components.
For Dielectric Protectant:
Allow cleaned components to dry before
repowering.
|
|
|
 |
|
|